Herringbone conveyor belts are a type of patterned conveyor belts, which are widely used in patterned conveyor belts and are used in high-quality patterned conveyor belts in various industries.
A chevron conveyor belt refers to a conveyor belt with a chevron pattern. The type of pattern is to avoid material slippage and friction. Since the transportation angle of the herringbone pattern conveyor belt is generally 0-30 degrees, it can effectively help the material to be lifted to the specified height.
The design structure of the herringbone pattern conveyor belt is common, and the template is designed as a herringbone structure, that is, one side of the pattern is closed, and the other side is a non-crossing opening tooth. The side of the opening tooth is the same, and the side of the closed mouth is various, including fully open and unblocked, semi-closed, and fully closed. This is designed according to different transportation conditions. The requirements are According to the actual situation.

Herringbone conveyor belt maintenance
　　 1. The conveyor belt should be kept clean during transportation and storage, avoid direct sunlight, rain and snow, prevent contact with acids, alkalis, oils, organic solvents and other substances that affect the quality of rubber, and be 1 meter away from the heating device.

　　2. The relationship between the diameter of the transmission roller of the conveyor and the cloth layer of the conveyor belt, the matching of the transmission roller and the reversing roller, and the requirements for the roller groove angle should be selected reasonably according to the design requirements of the conveyor.

　　3. During storage, the temperature in the warehouse should be kept between -15℃ and +40℃, and the relative humidity should be kept between 50-80%. During storage, the conveyor belt must be rolled into a roll and placed without folding. The storage time should be turned once every quarter.

　　4. The running speed of the conveyor belt should not exceed 0.5 meters per second. When transporting large, abrasive materials and using a fixed pear-shaped unloading device, the low speed should be used as much as possible. When the speed exceeds the specified speed of the tape, the service life of the tape will be affected.

         5. In order to reduce the impact and wear of the material on the tape, the feeding direction should follow the running direction of the tape; the drop of the material falling into the sand pocket of the tape should be minimized; the feeding port should avoid directly above the roller or roller ; The belt receiving section should shorten the distance between the rollers and take buffer measures.